How Can I Customize My Trunk Liner or Cargo Liner?

You can customise the length of your trunk liner or cargo liner to fit your needs. If, for example, your side length differs to your center length, we can curve the rear edge of the trunk liner to fit. Here are the measurements we’ll need:

Side Length. Measure the left and right sides of your trunk from the base of your seats along the sides to where it touches the rearmost part of the trunk.

Center Length. Measure the center length of your trunk from the base of your seats straight back to the rearmost edge of your trunk where the tailgate closes.

US Trunk Liners are typically designed to fit between the wheel arches of your trunk. If your vehicle has wheel arches, this can give you the added benefit of extra storage on either side of the trunk liner. For some cars we may be able to do a slightly more fitted Trunk Liner, i.e The Trunk Liner will fit between the wheel arches and then flare out towards the tailgate.

In addition to the width measurements above, here are the measurements we’ll need:

Wheel Arch Length. Measure from the base of your seats to the point your arches begin to curve.

You can customize the height of the back and sides of your trunk liner or cargo liner to fit your needs.

Here are the measurements we’ll need:

Back Height. Measure the height of your back seat from the bottom, along the angle of your seats (if applicable) to the point you want your trunk liner to stop. We make your trunk liner back panel to match the angle of your rear seats.

Side Height. Measure the height of the side of your trunk to the point you want the sides of your trunk liner to stop.

**If your car has a parcel shelf, we can protect up to it, so your drop down or pull out parcel shelf can still be used.

We can customize your liner with a series of small punched holes along the high back seat panel, so with the supplied lacing you can easily secure it to your dog guard or rear seat headrests.

Our Bumper Protector is made to fit the width of the opening of your trunk. You can customise the Bumper Protector if you need a more narrow width.

Here are the measurements we’ll need:

Bumper Protector Width. Measure across your trunk opening for your preferred width. Also measure the length required allowing about 4 inches on the trunk base, and dropping down outside your car to the level required.